After Use; Power Cable Winding-System - Aigger Heavy Duty CSC5623A Gebrauchsanweisung

English
rectangular steam nozzle is fitted by pushing and twisting, and removed by pulling and
twisting. The rectangular steam nozzle can be used either with or without the cotton cover,
depending on cleaning requirements. Perfect for the care and cleaning of cushions, carpets, car
seats, bathrooms and kitchens.
Window attachment - Push the window attachment onto the rectangular steam nozzle until you
hear it click into place. You can now fit the window attachment to the concentration nozzle by
pushing it into place, and remove it by pulling it off after the work has been completed.
Perfect for cleaning windows, mirrors, ceramic tiles and surfaces and other non-porous,
smooth surfaces. Apply the steam evenly to the glass surface from a distance of about 20 cm.
Then switch the steam off and wipe the moisture off the glass from top to bottom in
strips using the rubber squeegee. Wipe the rubber squeegee and the lower edge of the window
dry after every strip.
Attention: glass surfaces can be shattered by the sudden application of excessive heat. Before
cleaning such glass surfaces with the steam-cleaner, warm them up by applying steam to the
surface from a distance of 20-25 cm. Continue by applying steam from a distance of 10-15 cm.
Remove the plug from the socket before fitting or changing accessories. The accessories will
become hot during use - allow them to cool down before replacement.

AFTER USE

Switch the cleaner off and remove the plug from the socket. Wait until the cleaner has cooled
down completely. Empty the water tank. Allow the inside of the water tank to dry out before
replacing the cover. Store the device in a dry area safely out of the reach of children.
Attention: before opening the tank cover to empty the tank, release the steam pressure by
pressing the steam switch on the steam gun, or allow the cleaner to cool down completely.

POWER CABLE WINDING-SYSTEM

(Illustration 12)
(is located at the bottom of the device)
To wind the power cable at the bottom of the device, you must press the middle of the round
circle at the bottom of the device. (A)
Then lift it up and turn it 180° fixed in its position.
Under this you will notice a small lever. (B) Slide this down, in the direction of the wheels. (C)
With both edges firmly in position you will be able to fully wind the mains lead around this.
To restore everything to the original state you repeat the above-mentioned steps in reverse
order.
24
Downloaded from www.Manualslib.com manuals search engine