Aigger Heavy Duty CSC5623A Gebrauchsanweisung Seite 23

English
Switchable floor nozzle
The switchable floor nozzle is used for the cleaning of large washable wall and floor areas. The
floor nozzle can be used either with or without a cloth cover.
Sensitive surfaces (wood, linoleum etc.) should always be cleaned using the cloth supplied.
Place the floor nozzle on the cleaning cloth and pull the cloth under the clips at both sides.
For cleaning stubborn dirt on less sensitive surfaces, the brush fitting can be extended by
pressing the setting button.
The cleaning effect of the cloth can be improved by turning and changing the cleaning cloth
regularly. To clean very dirty areas, move the cleaning nozzle over the surface more slowly in
order to increase the cleaning action of the steam.
Attention: the device is not suitable for cleaning unsealed wooden floors, soft plastics or
wooden furniture.
The floor nozzle is supplied with a separate connection fitting. To use the floor nozzle, push
the connection fitting onto the rear side of the floor nozzle, as shown in the diagram (one-time
assembly procedure). The floor nozzle is now fully assembled. (Illustration 7)
Integrated storage compartment (Illustration 8)
All the accessories are conveniently stored in the housing of the device. To reach the
accessories, you must place the device on a flat surface. Using the handle, you lift the upper
part of the device, while you keep the unlocking button for the accessories pressed with your
other hand. To replace the part on to the device, you place the upper part straight on the
bottom part and you press on it until it locks audibly. (Illustration 9)
Accessory adapter (Illustration 10)
Push the accessory adapter as far as it will go onto the connection nozzle of the steam gun
until you hear it click into place. The accessory adapter remains locked in this position. The
accessory adapter can be removed again by pressing the accessory connection button and
pulling the adapter off.
Concentration nozzle
The concentration nozzle is pushed directly onto the accessory adapter until it clicks into place.
It can be used with various fittings (jet nozzle attachment, brush attachment, 2-in-1 combi-
nozzle), depending on the task in hand.
The concentration nozzle can be used with various fittings for cleaning: inaccessible areas such
as corners, joints, blinds, radiators, WCs, taps, stainless steel, windows, mirrors, enamelled
surfaces, stain removal.
Jet nozzle attachment
The jet nozzle attachment can be fitted directly to the concentration nozzle. The jet nozzle
attachment is fitted by pushing and twisting, and removed by pulling and twisting.
Brush attachment
The brush attachment can be fitted directly to the concentration nozzle.
Choose the right brush attachment for the task in hand. The brush attachment is fitted by
pushing and twisting, and removed by pulling and twisting.
2-in-1 combi-attachment (Illustration 11)
Rectangular steam nozzle - The hand nozzle can be fitted directly to the adapter. The
23
Downloaded from www.Manualslib.com manuals search engine