Operation And Function - Aigger Heavy Duty CSC5623A Gebrauchsanweisung

English

OPERATION AND FUNCTION

Over-heating protection
The device is equipped with protection against overheating. The cleaner will switch itself off
automatically on reaching a to big temperature, in order to prevent over-heating. In this event,
please remove the plug from the socket immediately. Allow the cleaner to cool down for 30
minutes before resuming work.
Filling the water tank (Illustration 2)
Always ensure that the plug of the device is removed from the socket before filling or refilling
the cleaner with water. Remove the cover of the water tank by pressing it down and turning it
anti-clockwise. Fill the tank with 1L of water using the measuring beaker. Replace the cover and
close it tightly by turning in the clockwise direction. The water tank should be emptied after
use. Allow the inside of the water tank to dry out before replacing the cover.
Refilling the water tank
If the water tank needs to be refilled during use, first switch the cleaner off and remove the
plug from the socket. Before opening the tank cover to refill the tank, release the steam
pressure by pressing the steam switch on the steam gun, or allow the cleaner to cool down
completely.
The water tank can then be refilled as follows. Remove the cover of the water tank by pressing
it down and turning it anti-clockwise. Fill the tank with 1L of water using the measuring beaker.
Replace the cover and close it tightly by turning in the clockwise direction.
Even after a cooling down period of 5 minutes, the remaining water in the tank and the tank
cover locking screw will still be hot. Always take care when removing the tank cover locking
screw, since hot steam may be emitted and the thread can still cause burns. The filler opening
of the cleaner must never be opened during use (CONTAINER UNDER PRESSURE).
Attention: never fill the tank with anything but cold water. The use of any other fluids can be
dangerous, and can lead to damage of the heating element.
The use of distilled water is recommended particularly in areas with hard water, in order to
prevent the build-up of scale. Otherwise, use boiled water in order to prolong the working life
of the cleaner.
Power indicator light / On/Off switch
When the water tank has been filled, insert the plug into the socket. Switch the cleaner on by
pressing the on/off switch to On. The power indicator light (red) should then come on,
indicating that the cleaner is being supplied with power.
Ready display
The steam readiness light (yellow) will come on. The operating temperature will be reached
after about 11 minutes (steam readiness light (yellow) goes out). The device is now ready for
use.
In order to avoid injury, the steam should be switched off during breaks or pauses during work
by pressing the on/off switch to Off. If you leave the working area, please switch the cleaner
off, and remove the plug from the socket (by pulling on the plug, and not on the power supply
cable).
19
Downloaded from www.Manualslib.com manuals search engine