Use Accessories - Aigger Heavy Duty CSC5623A Gebrauchsanweisung

Steam-checking button (Illustration 3)
With the steam-checking button you can determine the steam emission. It is possible to
determine the quantity of steam between MIN (minimum), no steam and MAX (maximum),
maximum steam.
Should no steam come out of the device during use of the device, then check:
- If the steam-checking button is not set to minimum
- If the device has been switched on and if the device has reached the service temperature.
- If the children's protective device is in disorder.
- If all the connecting pieces have been properly mounted.
- If the steam tube has been properly mounted to the device.
Should the above-mentioned checking not lead to a result, please switch the device off and pull
the plug from the wall socket. Let the device cool down completely and then check if there is
water in the tank. If not, please fill the device as described at the header "filling the water tank".
Should there be sufficient water in the tank yet, please start using the device once more. If
there is still no steam coming from the device, then please contact us.
USE OF ACCESSORIES
Steam Gun (Illustration 4)
Before you can start using the device, you must be certain that the steam tube has been
mounted to the device correctly. You can also do this after you have mounted accessories to
the steam gun. Lift up the lid of the steam tube and see to it that you mount the tube in the
connection point in a proper manner. To do this, you must let the 6 small tubes connect to
each other properly. Push the two pieces well into each other.
The cleaner is ready for use when the yellow steam readiness light goes out. Ensure that the
child safety lock on the steam gun is off. When you now press the steam switch, steam will be
emitted from the nozzle. Direct the steam gun at a cloth first, until the steam is emitted evenly.
Now keep the steam switch pressed, and direct the steam jet at the surface to be cleaned,
removing the dirt by moving the steam jet over the surface. The steam jet will be stopped as
soon as you release the steam switch.
Safety Lock (Illustration 5)
When the lock is pushed to the forward position, the steam switch cannot be pressed. Push the
lock to the rear position to release the steam switch.
In order to ensure safe use, even in case of accidental contact with liquids, the steam gun is
insulated from the electrical power supply (zero-volt system).
When cleaning surfaces with the steam gun, wipe the surface dry afterward using a micro-fibre
or cotton cloth if necessary; this will also remove any excess moisture for thorough cleaning. In
order to control the steam temperature and cleaning power at the surface, move the steam gun
closer to or further away from the surface. Do not hold the steam jet concentrated for too long
on a single spot.
Extension tubes (Illustration 6)
Depending on the task in hand, you can fit one, two or three extension tubes. Push the
extension tube onto the connection nozzle as far as it will go until you hear it click into place.
Then fit the switchable floor nozzle.
Downloaded from www.Manualslib.com manuals search engine
English
21