Do Not Plug Unit In Before - Crc Smartwasher Sw-23 -Rgb Betriebsanleitung

7.1.4. Model SW-37
1. Remove the OzzyMat
it and lay it on the mat support grid located in
the lowest level in the sink. Make sure to lay the
OzzyMat white side up.
®
2. Place the false bottom in position in the sink.
3. Form the flexible nozzle to its desired
shape and be sure that the parts brush is inside
the sink

4. DO NOT PLUG UNIT IN BEFORE

ADDING OZZY JUICE
5. At start up, carefully add ± 95 liter of OzzyJuice
the SmartWasher
®
directly into the sink.
6. Plug the unit into a 220 VAC GFCI electrical outlet
7. The SmartWasher
®
hours to heat up to its selected optimal temperature
of 40°C (± 1°) or 46°C (± 1°). This temperature
will be maintained as long as the SmartWasher
plugged in and full of OzzyJuice
light is on, the heater automatically shuts off.
SmartWasher
BIOREMEDIATING parts washing system
USER INSTRUCTION MANUAL
from its package, unfold
®
®
by slowly pouring the solution
will take approximately four
. If the "Add Fluid"
®
ORIGINAL INSTRUCTIONS
to
®
is
®
®
32981 Plastic basket
33047
False bottom
32950
Multi-Layer OzzyMat
FL-4
33076
Mat support grid
33075
Drain basket 3 1/2"
Stainless steel
page 20 of 640