Installation Instructions - OdontoKoala Koala-Intro Bedienungsanleitung

INSTALLATION INSTRUCTIONS

1. Lift the hood that covers the fittings (figure 1)
2. Read on the fittings the direction indicated by the arrows (figure 2)
3. Close the water delivery valve located upstream of the unit hydraulic system
4. Connect the cold water inlet hose to the unit to the Koala® filter, in the output direction indicated by
the arrow. The output of the Koala® is a fast 8 mm graft
5. Connect the end of the cold water pipe from the network to the 8 mm graft in the inlet direction as
indicated by the arrow.
6. Open the water delivery valve located upstream of the unit hydraulic system
7. Open the water and let it flow for about 5 liters
8. Check the seal of all hydraulic connections.
9. Koala® is now ready to supply 8,000 liters * of colorless water, odorless and bacteriologically pure
flavor
10
FIGURE 2
FIGURE 1