Herth+Buss ELPARTS 51305431 Einbauhinweis Seite 7

Fitting Instructions
Push the insulating ring provided over the
wires of contacts 1 to 4, position them on the
contact insert and press down until they tan-
gibly engage.
Insert the two remaining wire ends with the
crimped blade receptacles into the outer
chambers of the 3-way receptacle provided
(chambers 1 and 3, chamber 2 is not occu-
pied) and lock in place.
Press the contact insert into the socket hous-
ing again and position the 3-way receptacle
on the microswitch in the socket housing.
Push the rubber seal onto the socket and
screw the socket onto the retaining plate
with screws and nuts.
7
Warning!
a) When assembling the socket, take partic-
ular care that the connection wires of the
3-pin receptacle (green) are not trapped
and damaged!
b) The seal on the wire outlet from the sock-
et must sit on the insulating sleeve and
not just on the individual wires!
3. Functional check
Connect the earth wire to the battery again
and check all functions.
51305431
Technical data: