TTI TGR1040 Bedienungsanleitung Seite 19

Power on Settings
The following instrument status values are set at power on:
Registers marked thus are specific to the GPIB section of the instrument and are of limited use
in an RS232 environment.
The instrument will be in local state with the keyboard active.
The instrument parameters at power on are the same as at last switch off with the exception of
RF OUT which is always off.
If for any reason an error is detected at power up in the non-volatile ram a warning will be issued
and all settings will be returned to their default states as for a *RST command.
18
Downloaded from www.Manualslib.com
Status Byte Register
Service Request Enable Register
Standard Event Status Register
Standard Event Status Enable Register
Execution Error Register
Query Error Register
Parallel Poll Enable Register
manuals search engine
Status Model
= 0
= 0
= 128 (pon bit set)
= 0
= 0
= 0
= 0