Blodgett MT1828 Serie Bedienerhandbuch Seite 7

Installation
Oven Assembly
CONVEYOR
1. Slide the conveyor assembly through the left
hand tunnel opening until the sprocket is in-
side the control box. See Figure 5.
2. Install the drive belt on the motor and then
around the pulley on the conveyor assembly.
See Figure 6. Push the conveyor assembly
back to tighten the belt.
Downloaded from www.Manualslib.com
Figure 5
Figure 6
manuals search engine
NOTE: To reverse the direction of the drive motor
(if necessary), exchange A1 and A2. See
Figure 7.
WARNING!!
Disconnect the power supply before re-
versing the drive motor.
Y OR BL
S2 L2 L1
S3 S1
SPEED
A1 A2 A3
CONTROL
Figure 7
CRUMB PANS
1. Install crumb pans under each end of the con-
veyor.
Figure 8
6
W
AC
AC
V
GND
BK
DC MOTOR
W