General Standards And Warnings; Inspection Test And Guarantee; Inspection Test; Guarantee - CIBIN ALASKA VBT-TN Bedienungsanleitung

1. GENERAL STANDARDS AND WARNINGS

1.1 INSPECTION TEST AND GUARANTEE

1.1.1 Inspection Test

ALL CIBIN equipment must pass inspections and tests before it is dispatched.
Inspection test types are : - visual;
- leakage control;
- optimum vacuum attainment;
- electrical;
- operational;
Equipment is dispatched ready for use. Passing of inspection tests is certified in the specific annexes.
GB

1.1.2 Guarantee

Our equipment and the component parts manufactured by us are guaranteed for 1 year from the date of manufacture,
against any defect in workmanship.
Materials found to have defects must be returned carriage free to the factory of dispatch, where they will be checked
and repaired or replaced in the event that, in our final judgement, they are found to be defective.
It will be the specific task of the manufacturer to repair any defects on condition that the equipment has been correctly
used in full respect of the guidelines given in the manuals.
This guarantee does not cover chance defects such as those caused during transport, handling or interventions carried
out by personnel not authorised by us, improper use, or the incorrect installation of the equipment. Materials replaced
under guarantee will remain our property.

1.2 FOREWORD

This manual contains all information necessary for the correct installation, use and maintenance of the equipment.
The manual is for technical personnel who are qualified to install and service the equipment. It is also for the end
user in order to ensure that he or she will use the equipment correctly.
The manual is to be considered as an integral part of the machine. It is obligatory for the user to read it carefully and to
refer always to the manual before carrying out any installation or start operations. The manual, or in any case a copy the-
reof, should always be kept in close proximity to the machine in order for consultation by the end user whenever neces-
sary.
Tampering with this manual, even partially, is strictly forbidden (copyright ©).
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE OF THE MACHINE.

1.3 MACHINE DESCRIPTION

The machines described in this manual are refrigerator units with air condensers, manufactured as "monobloc" units. The
monobloc includes :
- a condenser on the cold room exterior.
- an evaporator on the cold room interior.
- a remote control panel or control panel placed on the condenser.
- supplied fittings.
The monobloc is a machine that is ready for operation when installed in its seating on the cold room wall. This machine
has been manufactured exclusively for use as follows :
TO MAINTAIN A DETERMINED TEMPERATURE IN A COLD ROOM SUITED FOR THIS USE
This line of "ALASKA" monoblocs is destined for installation on cold room walls. It is used for cell temperatures that vary
between -20°C and +10°C.
The cyclic defrosting system is fully automatic and operates using "hot gas ".
The CIBIN monobloc operates using a refrigerator compressor with a rotary motion, which operates using the power sup-
ply mains (single phase) and refrigerant.
The refrigerant flows into the evaporator and cools its surrounding atmosphere (by absorbing the heat). The "hot" fluid is
sucked in/compressed by the compressor and sent to the exchange battery ("condenser") to regain its cooling capacity.
The cycle is then repeated.
18