Community Playthings A301 Montageanleitung

Installation instructions
A301 Wall-mounted welly storage
Installation
A competent carpenter or maintenance person should install your Wall-mounted welly storage.
Do not install item against a skirting board. If there is a skirting board, cut out the board or mount the item above it
(see pictures below).
1. Select fasteners that suit the wall construction (fasteners not included). Position the Wall-mounted welly storage at the
desired place on the wall.
2. Choose a suitable location for each fastener. You will need at least four: two in the top cleat and two in the bottom cleat,
near each corner of the item (see picture below).
3. Predrill the solid wood cleats at these locations.
4. Attach the Wall-mounted welly storage to the wall with at least four fasteners that are suitable for the wall construction
and the weight of the fully loaded item.
WARNING
The Wall-mounted welly storage must be properly mounted to a wall before use.
It is the customer's responsibility to ensure that the item is securely attached.
Fasteners
Cut out skirting board to install item.
Use this method to provide best access for children.
Community Playthings, Brightling Road, Robertsbridge, TN32 5DR
communityplaythings.co.uk • sales@communityplaythings.co.uk • 0800 387 457
© 2020 by Community Products (UK) Ltd • BM29 Eu 0580 Revision 01
Or install item above
skirting board.
Do not install item against
skirting board.