Kress KI200 Handbuch Seite 14

top point), and the measured value will be
displayed as value 1; keep the instrument
level which performs horizontal measurement
by default; take the second measure by
referring to the blinking side (as shown
in the figure above, aiming at the middle
vertical point), and the measured value will
be displayed as value 2; then make the third
measurement (aiming at the bottom point),
and the measured value will be displayed as
value 3. The calculated distance result will be
displayed on the summary line.
The instrument can also calculate the
14
distance by using the angle measurement and
Pythagorean theorem. This function allows
EN
you to measure distances for inaccessible
locations.
Note:
1. All the points to be measured should be on the
same vertical plane. (The angle sensor can only
measure the angle of vertical line)
2. In order to get more accurate measurement
results, it is recommended to use a tripod to rotate
the instrument on the same axis for measurement.
The angle between the instrument and the
horizontal plane is displayed on the screen in
real time.
Indirect measurement: auto horizontal
Press
horizontal symbol
As shown in the figure, press
the length of the bevel edge 1. The angle, bevel
distance, vertical distance, horizontal distance will
be displayed on the screen.
1. The first
measurement/hypotenuse
2. The second
measurement/right-angle side
3. The third
measurement/hypotenuse
4. The caculated distance
five times in a row, once, the auto
appears in the screen.
to measure