Functions And Operations - Kress KI200 Handbuch

2. Measure button
Short press
then press
measurement.
3. Return/Clear button
Short press
clear measured value.
4. Setting measuring reference
The default reference setting is from the
rear of the instrument. Press
switch the reference point to the front
reference or tripod reference. Press it
again to switch back and forth between
the front, middle and rear.
*The reference point will be set to default
every time when it is rebooted.
10
EN
5. Unit setting
Long press
between m, ft, in and ft+in.
The measuring unit will automatically switch
to "m" after restarting.

FUNCTIONS AND OPERATIONS

1. Single distance measurement
Press
then press
measurement.
The laser is turned off after completion of
measurement, and the measured value is
displayed immediately.
Note: After power on, the instrument enters
the single measurement mode by default.
After selection of measuring position, press
; in other measurement modes, press
to go back to single measurement.
to turn on the laser, and
again to trigger single
to undo the last action or
to change distance unit
to activate the laser, and
again to trigger single
to