General Safety Information; Setting Up The Product; Repairs - Philips NeoPix Easy 2+ Bedienungsanleitung

1 General safety
information
Take note of all warning and safety notes
indicated. Do not make any changes or
settings that are not described in this user
manual. Incorrect operation, and improper
handling can lead to physical injury, damage
to the product or loss of data.

Setting up the product

This product is for indoor use only. Place the
product securely on a stable, flat surface.
To help avoid possible injuries to persons
or damage to the product itself, position all
cables in such a way that no one will trip
over them.
Do not operate the product in damp rooms.
Never touch the mains cable or the mains
connection with wet hands.
The product must have sufficient ventilation
and must not be covered. Do not put the
product in closed cabinets, boxes, or other
enclosures when in use.
Protect the product from direct sunlight,
heat, intense temperature fluctuations
and moisture. Do not place the product in
the vicinity of heaters or air conditioners.
Observe the information on temperature
listed in the technical data (see Technical
data, page 17).
Prolonged operation of the product causes
the surface to become hot. In case of
overheating, the product automatically
switches to standby mode.
Do not allow liquids to leak into the product.
Turn off the product and disconnect it
from the mains supply if liquids or foreign
substances leaked into the product. Have
the product inspected by an authorised
service centre.
Always handle the product with care. Avoid
touching the lens. Never place heavy or
sharp objects on the product or on the
power cable.
If the product gets too hot or emits smoke,
shut it down immediately and unplug the
4
power cable. Have your product checked
by an authorised service centre. Keep
the product away from open flames (e.g.
candles).
DANGER!
Risk of explosion with incorrect type
of batteries!
There is a risk of explosion if the wrong
battery type is used.
Do not expose the batteries (battery pack or
embedded batteries) to excessive heat such as
sunshine, or open fire.
Under the following conditions, a layer of
moisture can appear inside the product which
can lead to malfunctions:
• if the product is moved from a cold to a
warm area;
• after a cold room is heated;
• when the product is placed in a damp
room.
Proceed as follows to avoid any moisture
buildup:
1 Seal the product in a plastic bag before
moving it to another room, in order for it to
adapt to room conditions.
2 Wait one to two hours before you take the
product out of the plastic bag.
The product should not be used in a very dusty
environment. Dust particles and other foreign
objects may damage the product.
Do not expose the product to extreme
vibrations. This may damage the internal
components.
Do not allow children to handle the product
without supervision. The packing materials
should be kept out of the hands of children.
For your own safety, do not use the product
during thunderstorms with lightning.

Repairs

Do not repair the product yourself. Improper
maintenance can result in injuries or damage to
the product. The product must be repaired by
an authorised service centre.
Please find the details of authorised service
centres on the warranty card supplied with this
product.
Do not remove the type label from this product,
as this will void the warranty.
Philips · NeoPix Easy 2
+