Glow Fire Uranus Bedienungsanleitung Seite 19

Note When the heater is put into operation for the first time, a slight odour may occur.
This is normal and should not occur again unless the heater is not used for a
longer period of time.
Note To improve operation, point the remote control towards the front of the fireplace.
DO NOT press the buttons too quickly. Allow the appliance time to respond
to commands.
Temperature limiting control
The heater is equipped with a temperature limiting control. If the heater reaches an unsafe
temperature, the heater will automatically switch OFF. Reset:
1. pull the power plug from the socket.
2. set the ON/OFF switch to ON and the TOUCH CONTROL PANEL to OFF Wait 5
minutes.
3. Inspect the fireplace to make sure that no ventilation openings are blocked or
clogged by dust or lint. In this case, clean the ventilation openings with a vacuum
cleaner.
4. turn the ON/OFF switch to OFF and reconnect the power cord to a wall outlet.
5. If the problem persists, have the outlet and wiring inspected by a qualified
technician.
Battery instructions for the remote control
The remote control uses ONSCR2025 battery (included)Temperaturbegrenzungsregelung
NEVER throw the batteries into a fire. Failure to observe this precaution
may result in an explosion. Dispose of the batteries at your local
collection point for hazardous materials.
Care and maintenance
ALWAYS turn the heater OFF and unplug the power cord from the wall
outlet before cleaning, servicing or transporting this heater. Failure to do
so may result in fire, electric shock or injury.
NEVER immerse or spray in water. This may result in fire, electric shock
or injury.
Metal:
•
Clean with a soft cloth moistened with a citrus oil based product.
•
DO NOT use brass polish or household cleaners because these products will damage
the metal bar.
Glass:
•
Spray a high-quality glass cleaner on the cloth or towel. Dry thoroughly with a paper
towel or lint-free cloth.
19
Glow Fire Uranus
Stand: 09/2020
Version: 1