Glow Fire Uranus Bedienungsanleitung Seite 18

Timer
Flame
Color
Temperature
Heater
Back Lights
18
OFF: Disables control panel
functions and remote control.
Turns the flame effect off.
TIMER button: Controls timer
settings to turn off the heater
at the selected time. Setting
range from 0.5 to 8 hours.
FLAME button: Makes the
flame effect darker and
brighter. NOTE: Flame effect
will remain on until the power
button is turned off. Flame
effect must be on to turn the
heater on.
COLOR button: The color of
the flame effect changes.
NOTE: Flame effect color will
remain until the Power button
is turned off. The Flame Effect
color must be on to turn the
heater on.
TEMPERATURE button:
Switches the heating on and
off.
NOTE: Press the button for 5
seconds, the temperature
setting switches from °C to °F.
In the same way from °F to °C.
HEATING key: Switches the
heating on and off.
NOTE: The heater only works
when the flame effect is on. If
the flame effect is off, the
heater will not turn on.
NOTE: To prevent
overheating, the heater fan
blows cold air for 8-10 seconds
before the heater turns on and
after it turns off.
BACKLight button: Changes
the color of the backlight
NOTE: The rear lights remain
on until the power switch is
turned off. Works only when
touched on the control panel.
2. Press again. Flame effect
switched off. Machine in standby.
All functions switched off.
1. Press once. Indicator light
switched on. Timer is set to 0.5
hours.
2. Press again until the desired
setting is reached. Display lamps
indicate the setting.
1. Press once. The brightness of
the Flame effect changes.
2. Press again until the desired
setting is reached.
1. Press once. The color of the
flame effect changes.
2. Press again until the desired
setting has reached a total of 3
colors.
1. Press once: touch control panel
display is activated
2. Press again: until the desired
setting is reached. Digital display
shows setting cycles, see below:
1. press once. The control lamp
lights up. Blower blows cold air for
10 seconds. The 750 W heater
switches on and blows out warm
air.
2. press again. The control lamp
lights up. The 1500W heater turns
on and blows out warm air.
3. press again. The heater
switches off. The blower blows cold
air for 10 seconds, allowing the
heater to cool down and then
switches off.
1. Press once. Flame color effect
changes.
2. Press again until the desired
setting is reached. 3 colors.
3. Press the third time, the
backlight is switched off.
Glow Fire Uranus
Stand: 09/2020
Version: 1