Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX Input via USB
If a DMX signal is applied to the XLR input, the interface will automatically
send the data to the computer via USB. Receiving DMX data via USB
requires additional configuration of your software application. For further
information, please refer your application's documentation.
Reset to Default Settings
The interface can be reset to its factory settings by following the steps below.
1
Keep the reset button pressed with a thin object while the interface is
powered on. After 5 seconds, all current settings of the unit will be
deleted and replaced by the factory settings. The unit reboots and all
4 status indicators will start flashing red.
2
Shortly disconnect the interface from the power supply.
3
Re-establish the power supply. The interface starts with the factory
settings. The first status indicator will be flashing red to indicate that
no user password has been assigned to the interface. A new
password can be set with the first mobile device the interface is paired
with.
Note: Simply repeat these steps, should the procedure fail.
After Use
After the operation, disconnect the mains plug of the power supply unit from
the socket, to prevent unnecessary power consumption.
www.eurolite.de
42
Werbung
Inhaltsverzeichnis
