Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
SETUP
1
For Wi-Fi operation, setup the interface in a location close to where
you will be using your mobile device. Screw on the antenna provided
to the antenna input and put it in a vertical position. An extension or
more powerful antenna may be used in difficult reception situations.
2
Connect your DMX controlled devices (e.g. LED spot lights, moving
heads and dimmers) to the XLR output DMX OUT. For DMX input,
connect a DMX control unit to the XLR input DMX IN.
The XLR jack is equipped with a lock which is released by pressing
the PUSH lever down and pulling the microphone plug out at the same
time.
Notes: DMX input and DMX output cannot be used simultaneously.
In Wi-Fi mode, both XLR connectors provide a DMX signal. If
necessary, an XLR adapter may be used to take off the DMX signal at
the DMX input.
3
Power on the interface by connecting the power supply unit provided
to the corresponding input on the device and to a mains socket (100-
260 V~, 50/60 Hz). Thus the interface is powered on. By
disconnecting the unit from the mains it can be switched off.
All four status indicators will light up red and indicate that the interface
is ready for operation. If the status indicators start flashing red, the
interface requires a firmware update in order to operate →chapter 8.
4
Now, the interface sets up its own Wi-Fi network and mobile devices
may be connected. Alternatively, it may be connected to a computer
via its USB port for operation with lighting control software.
www.eurolite.de
32
Werbung
Inhaltsverzeichnis
