Faults - Siemens ER926SB90E Gebrauchsanweisung

Faults

Fault
The general electrical
system is malfunctioning.
The automatic switching on
function does not work.
The burner flame is not
uniform.
The gas flow is not normal
or there is no gas.
The kitchen smells of gas.
The burner immediately
switches off after releasing
the control knob.
14
Sometimes certain faults detected can be easily
resolved. Before calling the Technical Assistance
Service, bear in mind the following advice:
Possible cause
Defective fuse.
The automatic safety switch or circuit
breaker has tripped.
There may be food or cleaning
products stuck between the ignition
sparkers and the burners.
The burners are wet.
The burner caps are not correctly
positioned.
The appliance is not earthed, is poorly
connected or the earthing is faulty.
The burner components are not
correctly positioned.
The grooves on the burner are dirty.
The gas supply is blocked via
intermediary valves.
If the gas is supplied from a gas
cylinder, check that this is not empty.
A gas tap has been left on.
Incorrect coupling of gas cylinder.
Possible gas leak.
The control knob was not held down for
long enough.
The grooves on the burner are dirty.
Solution
Check the fuse in the main fuse box and
change it if it is damaged.
Check the main control panel to see if the
automatic safety switch or circuit breaker
has tripped.
The space between the ignition sparker and
the burner must be clean.
Dry the burner caps carefully.
Check that the covers are correctly
positioned.
Contact the installation technician.
Correctly place the parts on the appropriate
burner.
Clean the grooves on the burner.
Open all gas taps.
Change the gas cylinder.
Turn off the taps.
Check that the coupling is sound.
Shut off the gas supply, ventilate the
premises and immediately notify an
authorised installation technician so that they
can check and certify the installation. Do not
use the appliance until you are sure that
there is no gas leak in the installation or
appliance itself.
Once the burner is on, hold the control knob
down a few seconds longer.
Clean the grooves on the burner.