Blaupunkt HOR801 Bedienungsanleitung Seite 9

HOR801
TECHNICAL DATA
Voltage: 220-240V~50Hz
Power: 2500W
A. Radiator body
B. Control panel
C. Base with castors
D. Handle
E. Remote-control-storage compartment
F. Main power switch
BEFORE THE FIRST USE
Space out the feet with the castors on the radiator base according to the diagram in the Figure.
Place the radiator on a level, stable, and heat-resistant surface.
USING THE APPLIANCE
Connect the radiator to the power source. Switch the appliance on with the main power switch (F).
After that, two buttons on the control panel light up: the timer and the power switch. The appliance
will then be in the standby mode.
Press the power switch to turn on the radiator.
The radiator switches on in the Eco mode, and the target temperature is set at 23°C.
Temperature changing: Press the temperature-setting button, then press the + or - buttons to change
to the required temperature. After setting to the required temperature, the radiator will switch to the
Eco mode. The temperature can be set within the range 10-30°C and in the anti-freeze mode at 5°C.
Note: the temperature value on the display shows the set required temperature. This is not an ambient-
temperature measurement.
Changing the operating mode: To change the heating mode, press the operating-mode-selection
button:
The eco mode -> High power -> Medium power -> Low power. In the eco mode, the radiator adjusts the
power to the ambient temperature. When one of the constant-power modes is used, the appliance will
only operate at the selected power level. When the selected target temperature (default 23°C) is
reached, it will switch off. When the temperature drops, the appliance will start heating again.
The eco mode: To activate the eco mode, press the operating-mode button until the eco mode is
selected.
In this mode, the radiator adjusts the heating power to the ambient temperature. The smaller the
difference between the required temperature and the ambient temperature the lower the power used
to heat the room. If there is only one degree of difference, the radiator will operate in the low-power
mode. When the difference is 3 degrees, the radiator will use the maximum power.
The radiator's delayed-switch-on function: The radiator should be in the standby mode. Press the timer
button. The hour symbol (H) and the time (0) will appear on the display. Use the + or - buttons to select
the expected switch-on-delay time of the radiator. In the range 0 to 5 hours, the increase is 0.5 hours,
while above 5 hours to 24 hours the increase is 1 hour. After the selected time has elapsed, the
appliance will start heating.
After setting the timer, you can set the radiator operating parameters by using the temperature-
setting button or the operating-mode-selection button.
CAUTION: It is worth remembering that when using the radiator's delayed-switch-on function, the
appliance can switch on when left unattended. Always observe all the safety instructions for the
product's use.
G. Cable reel
a) Power button
b) Power-/operating-mode selection button
c) Temperature-setting button
d) Timer button
e) "-" Button
f) "+" Button
7