Elbur Rubens 3 Gebrauchsanweisung Seite 11

EN
Notes
There must be enough space available for adjusting the overbed table
tray, its position and height,
RUBENS 9 can be located on both sides of the nursing bed, due to its
construction, without loss of functionality.
Assembly of RUBENS 9 should be performed in the following order
(numbers in brackets referred to the picture attached above):
1) carefully bring all components out of the box,
2) put bottom frame on four castors (3) on flat, horizontal surface,
3) push the castor lever down as far as it goes for the purpose of activating
the brake (during the use for the purpose of deactivating the brake push the
foot lever toward as far as it goes),
4) connect bottom frame (3) with vertical bar (2) using two allen screws (1),
5) put movable support (5) into vertical bar (2),
6) attach permanent part of the desktop to movable support bar and connect
it with fixed angle using two allen screws and flat spacer (1), which should
go between movable support bar and angle,
7) read carefully subclause 6.2 to understand how to adjust height
of the overbed table.
Elbur sp. z o.o. sp.k.
RUBENS Overbed tables
11 z 36