Selecting The Sensor; Language - OJ Electronics OCC4 Benutzerhandbuch

OCC4/OCD4
30 seconds after the last key press.
• On: Backlighting continuously on.
• Heating active: Backlighting comes on when heat is called for
by the thermostat.
Select the desired backlighting setting and confirm with OK.

Selecting the sensor*

Floor sensors other than the supplied
(12 kΩ/ 25 °C) can be selected with this
menu. The thermostat is preprogrammed for
4 other types:
Sensor 2 kΩ
Sensor 10 kΩ
Sensor 15 kΩ
Sensor 33 kΩ
Select the installed sensor with the arrow keys, then confirm with
OK. The resistance characteristics of the sensor for 15 °C, 20 °C,
25 °C and 30 °C are now displayed.
If the installed sensor does not have the same characteristic as
that shown in the thermostat display, change the values at the four
listed temperatures using the arrow keys.
Confirm with OK to switch to the next resistance characteristic.
Select Information with the arrow keys, then confirm with OK.
The display now shows the resistance characteristic of the selected
sensor. Then confirm with OK. The new sensor values are now
stored in the thermostat.
*Only for thermostats with floor sensor.
NB! If the incorrect sensor is selected there is a risk that the ther-
mostat will not be able to regulate to the desired temperatures and
therefore damage to the floor construction or covering may occur.

Language

Allows the language used on the display to
be changed.
Press OK and select the required language.
Confirm with OK.
12
© 2014 OJ Electronics A/S
English
Sensor

OK

Language

OK

OCC4/
Factor
Allows
person
setting
Press O
Confirm
Inform
Display
Back
In vario
you wil
Use Ba
Exit
Return
ERROR
If a fau
as follo
E0: Int
Re
E1: Int
E2: Ex
E5: Int