Energy Monitor; Engineer Settings; Offset Temperature - OJ Electronics OCC4 Benutzerhandbuch

OCC4/OCD4

Energy monitor

Allows you to view energy consumption for
the past 2 days, 30 days or 365 days.
Press OK for the chosen period. The value
in per cent (%) shows the relative amount of
time the heating has been on. The following figure is the cost for
the selected period. To ensure correct calculation, check the set-
tings for currency, price per kWh and load.
Currency: Press OK and chose the required currency.
Confirm with OK.
Cost/unit: Press OK and set the actual cost of electricity.
The cost must be entered per kWh. Press OK.
Load: Press OK and enter the connected heating power.
The value must be in watt (W). Press OK.
Leave the menu by pressing Exit.

ENGINEER SETTINGS

The Engineer settings menu contains the
following options:

• Offset temperature

• Adaptive function
• Application
• Temperature scale
• Display illumination
• Selecting the sensor
• Language
• Factory reset
• Information
Offset temperature
If the actual measured temperature does not
corresponding to the thermostat value, you
can adjust the thermostat by offsetting the
temperature.
Press OK and enter the value of the measured temperature. Con-
firm with OK.
10
© 2014 OJ Electronics A/S
English
Energy monitor

OK

Engineer settings

OK

Offset temp.

OK

OCC4/
Adapti
Ensure
already
mornin
a few d
automa
Press O
Applic
Set the
There a
Floor r
Room
Room/
Regula
Press O
Tempe
Allows
within w
then on
this ran
Press O
to sele
select t
with OK
Displa
There a
lighting
• Auto
key