Sony BRAVIA FW-85BZ40H Referenz-Anleitung Seite 14

2
Attach the Wall-Mount Attachment
(supplied with the LCD Monitor) to the
rear of the LCD Monitor (to make it
parallel with the wall).
Note
• If using an electric screwdriver, set the torque at
approximately 1.5 N·m {15 kgf·cm}.
• Be sure to fasten the Wall-Mount Attachment when
attaching them to the LCD Monitor.
Use only a flat head screwdriver to install the
Wall-Mount Attachment. Use of another tool might
result in over torqueing the Wall-Mount Attachment
and damaging the LCD Monitor.
14
GB
VS
1.5 N·m
{15 kgf·cm}
Detaching the Table-Top Stand from the LCD
Monitor
1
Remove one side of the Table-Top Stand
at a time. Firmly hold the Table-Top
Stand securely with both hands while
the other people lift up the LCD Monitor.
2
Repeat the previous step and remove
the other side of the Table-Top Stand.
Note
• Three or more people are required to detach the
Table-Top Stand.
• Be careful not to use excessive force while detaching
the Table-Top Stand from the LCD Monitor as it may
cause the LCD Monitor to fall resulting in personal
injury or physical damage to the LCD Monitor.
• Take care when handling the Table-Top Stand to
prevent damage to the LCD Monitor.
• Be careful when lifting the LCD Monitor as the
Table-Top Stand is detached, the Table-Top Stand may
topple over and cause personal injury.
• Take care when removing the Table-Top Stand from
the LCD Monitor to prevent it from falling over and
damaging the surface that the LCD Monitor is sitting
on.