Specifications; Installing The Batteries - Restek ProFLOW 6000 Bedienungsanleitung

2.0 Specifications

Table I:
Type of measurement
Accuracy of measurements
Power requirements
Operating flow range
Operating temperature range
Available communication
Warranty
Calibration
Certifications
Compliance

3.0 Installing the batteries

This unit uses two AA alkaline batteries.
polarity (⊕ and ⊖) correctly aligned. Close the cover. (Figures 2 and 3.)
To install batteries, extend the wire stand. Open the cover. Insert the batteries with the
• Load the new batteries with their polarity (⊕ and ⊖) aligned correctly.
Precautions for battery replacement:
• Do not use rechargeable batteries.
Figure 2: Extend the wire stand before
opening battery door.
www.restek.com
4
Volumetric flow
± 2% of flow reading or ± 0.2 mL/min, whichever is greater
2 AA alkaline batteries 1.5 V DC each/3 V DC 200 ma
0.50 to 500 mL/min
32 °-120 °F (0 °- 48 °C)
USB type B data port
One year (excludes recalibration)
NIST traceable
Yearly recalibration is recommended
CE, Ex (see section 10.0)
WEEE, RoHS 2, China RoHS 2 (see section 10.0)
– +
Figure 3
Insert the batteries
as marked.
–
+