Maintenance - Inventum ST308WZA Gebrauchsanleitung

5
use
Check that the voltage stated on the information plate matches the voltage used in your region.
SWITCHING ON THE VACUUM CLEANER
1. Place the vacuum cleaner on a sturdy and flat surface.
2. Carefully pull the cord out of the vacuum cleaner until you reach the required length and insert the plug in a power socket.
3. Switch on the vacuum cleaner by pressing the on/off button
4. Depending on the surface to be cleaned, you can adjust the suction power. Use the + and - button on the handle or vacuum
cleaner to set the required suction power. The active modes light up.
minimum suction power
medium suction power
maximum suction power
5. Depending on the surface to be cleaned, you can adjust the brushes in the floor nozzle.
When cleaning hard floors, you must make sure the brushes are extended.
When cleaning floor coverings or floor cloths, the brushes must be retracted.
When it is difficult to move the floor nozzle over the floor, you can adjust the suction power with the + and - button on the handle.
PAUSE / SWITCH OFF THE VACUUM CLEANER
PAUSE
Press the on/off button
SWITCH OFF
Fully switch off the vacuum cleaner by pressing the on/off button
the socket, hold the plug and allow the cord to wind automatically by pressing the button for automatic rewinding
Guide the cord with your hand to prevent possible damage. The cord is automatically wound up in the vacuum cleaner.
6

maintenance

Regularly check the hose, dust bag and filter to prevent problems. Empty the hose when it is clogged. Replace the dust bag when
it is full and clean or replace the filters when they are dirty.
DUST BAGS AND FILTERS
The disposable dust bag and the motor filter are important parts for the efficiency of the vacuum cleaner. The dust bag is for
collecting dirt, but at the same time the motor filter should be porous enough to allow sufficient air to pass through.
When the dust bag and motor filter are full, air is no longer able to pass, making it impossible for the vacuum cleaner to pick up dirt,
irrespective of how powerful the motor is.
That is why it is important that the dust bag is replaced regularly and that the motor filter is replaced after each fourth dust bag
replacement to guarantee optimum functioning of the vacuum cleaner. The air flow can quickly reduce when fine particles are
picked up. Due to these fine particles, the performance of the vacuum cleaner will deteriorate, even if the dust bag is not yet full.
It is therefore possible that the dust bag and motor filter should be replaced more frequently when picking up carpet cleaners,
powders, dust generated during plastering work or other fine dust particles.
REPLACING THE DUST BAG AND MOTOR FILTER
Check that the vacuum cleaner is off and remove the plug from the socket before replacing the dust bag
or motor filter.
Never use the vacuum cleaner without a dust bag or motor filter.
• Replace the dust bag when the dust bag full indicator
to be full.
• Open the dust bag compartment by pushing the handle upwards. Lift the cover.
• The motor filter [1] must be replaced after every fourth change of dust bag. Remove the motor filter
by sliding it upwards. Place a new motor filter and place it back in place.
• Carefully slide the full dust bag out of the dust bag holder [2] and throw the full dust bag away.
18
• English
Delicate materials, curtains
Furniture cushions, high quality carpets, rugs
Normal carpets and mattresses
Long pile carpets
Hard floors such as tile, wood and pvc floors.
on the remote control to pause the vacuum cleaner. Press the button once more to continue vacuum cleaning.
with your foot.
on the vacuum cleaner with your foot. Remove the plug from
becomes red or when the dust bag seems
with your foot.
1
2
1