RaidSonic Technology ICY DOX IB-RD3741-C31 Handbuch Seite 20

Follow the description above for SET 2 but start as follows:
To select the desired RAID mode for the lower two drives.
Press and hold the "SET 2" button until the green RAID option light starts to flash.
Then release the button and press it briefly several times to select the desired mode.
RAID 1 rebuild settings
Situation: The red ERROR LED indicator of the related RAID set at the front panel turns red and the red LED of the slot
within the defective drive blinks red.
1. Remove the failed drive out of the slot which LED indicator turned red before.
2. Install the new drive in the position of the removed drive (the volume of the new drive should be equal to the
removed one).
3. The rebuilding will start automatically. The HDD LEDs at the front panel display breathing purple lights. This indica-
tes that it is now rebuilding the RAID array.
4. Rebuilding of the RAID 1 array will take several hours, depending on the drive capacity. When the data has been
restored, the HDD LEDs at the front panel will turn a steady blue.
Note: We recommend not turning off the power during the rebuild process but if the process is interrupted, it will conti-
nue rebuilding the data as soon as the power is turned back on.
Note: If necessary, check the device manager and disc manager if the HDDs of the RAID1 array are working.
Note: If necessary, you need to assign a drive letter to the HDDs of the RAID1 array.
About data security
To protect your files and help prevent the loss of your data, we strongly recommend that you keep two copies of your
data, one copy on your IB-RD3741-C31 and a second copy either on your internal drive or another storage media
such as CD, DVD, Tape or an additional external drive.
Any loss or corruption of data while using the IB-RD3741-C31 is the sole responsibility of the user, and under no circum-
stances will the manufacturer be held liable for compensation or the recovery of this data.
Manual IB-RD3741-C31