Contents Of Carton; Unpacking; Assembly - GMC MAG2050R Handbuch

• Always switch off and wait until the bit has come to a
complete standstill before removing the machine from the
workpiece.
• Do not touch the bit immediately after operation. It may
be extremely hot and could burn your skin.
• Rags, cloths, cord, string and the like should never be left
around the work area.
• Use safety equipment including safety goggles or
GB
shield, ear protection, dust mask and protective clothing
including safety gloves.
WARNING. Before connecting a tool to a power source
(power point receptacle, outlet, etc.) be sure that the voltage
supply is the same as that specified on the nameplate of
the tool. A power source with a voltage greater than that
specified for the tool can result in serious injury to the user,
as well as damage to the tool. If in doubt, do not plug in
the tool. Using a power source with a voltage less than the
nameplate rating is harmful to the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool's construction and
design:
• Damage to hearing if effective ear muffs are not worn.
• Harmful emissions of wood dust when the machine is
used in closed rooms. Always use supplementary dust
extraction.
• Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the bit.
• Contact with the bit.
• Reaching into the housing whilst the tool is running and
making contact with the bit.
• Kickback of workpiece and parts of workpiece.
• Bit fracture.
• Catapulting of faulty pieces from the bit.
• Do not use bits that are deformed or cracked.
• Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the bit and setting the depth of cut.

Contents of carton

The router is supplied with the following accessories as
standard:
• 5 Collets 1/4", 1/2", 6mm, 8mm, 12mm
• Parallel guide with dust extraction adaptor
• Dust extraction adaptor
• Template guide
• Wrench
• Dust cover

Unpacking

Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.

Assembly

The GMC Electric Router is packed, fully assembled except
for the dust extraction adaptor and parallel and template
guide.
6