Additional Information; Service And Maintenance - Eldom RH10N Montage-, Betriebs- Und Wartungsanleitung

EN
which information is available. Each graph shows the date to which it refers and the total electricity consumed
for that day. It should be borne in mind that the information on the electricity consumed is calculated on the
basis of the convector heater set power.
Pressing ▲ or ▼ button again moves to the hourly average room temperature graphs. The controller shall
store such information for the last 4 days. By pressing the ▲ or ▼ buttons, the charts shall change with the
days for which information is available. Below each graph is the date to which it refers.

Additional information

The display may show additional information such as:
Information about the condition of the WiFi module It is necessary to press the OK button once, then the ▼
button. If you purchased a device without WiFi control, the message No WiFi module shall be displayed.
Information about the controller hardware and software versions. It is necessary to press the OK button once,
then press ▼ twice.
Information about the appliance operation errors. All error messages are displayed in the corresponding field
on the display. Messages can be as follows:
Disconnected TS
TS short-circuit
Open window
Fallen appliance /
Colaps. devoce
Wrong Time !

SERVICE AND MAINTENANCE

Make sure to turn off the appliance first and remove the plug from the socket.
In order to preserve the unit technical characteristics and to prevent overheating is necessary, for example, once a month to
џ
clean the accumulated dust from the heater top with dry cloth and the bottom grid with a vacuum cleaner or a bristle.
Clean the cabinet with a dry cloth, vacuum cleaner or brush, always disconnecting the appliance from the power supply
џ
beforehand.
It is prohibited to use liquids when cleaning the unit. It is prohibited to use a steam generator!
џ
Do not use abrasive materials!
џ
Clean the rear of the convector once you have unlocked the two clamps at the top end of the convector as shown in fig. 5, so you
џ
can release and clean it.
Warning! After cleaning the heater back side it is compulsory to place the unit back in its normal position (according fig. 5.
џ
ADVICES FOR APPLIANCE PROPER USE
It is not necessary to set the unit in operation at highest temperature, the degrees in the room shall not climb up quicker.
When you ventilate or aerate the room for a long time, turn off the appliance from the button 1 or from the key on the right side panel.
When leaving home for few hours mind decreasing the temperature set.
Should you be absent for:
less than two hours it is not necessary to change the temperature set.
џ
from 2 (say: two) to 24 (say: twenty four) hours you may decrease temperature set with few degrees.
џ
More than 24 hours or in the summer - leave the appliance plugged into the mains and with a mechanical switch turned off by the
џ
electronic control unit (button 1). This will allow the antifreeze function to be switched on as required.
If you have more than one electric convector in the room you may switch them on simultaneously, thus securing constant temperature
without increasing power consumption. It is true also for rooms which are not permanently used – it is better to leave the units switched
on at minimum temperature stings than to switch them off completely.
WARRANTY, WARRANTY PERIOD AND WARRANTY CONDITIONS
The warranty, warranty conditions, warranty period, warranty validity for purchased appliance and service related manufacturer or
vendor liabilities during the appliance warranty period are listed in the appliance warranty form. When buying the appliance the warranty
form must be filled and signed both by seller and buyer. Keep the warranty form in a secure place.
In all instances shall be in force the applicable laws, regulations and other legislation dealing with the rights and obligations of
The room temperature sensor is switched off or interrupted.
The heater shall not work
The room temperature sensor is short-circuited. The heater shall not work.
The Open window mode is enabled.
Enabled protection when the appliance is decommissioned
The watch is not set. The weekly programmer will not work.
19
EN