Assembling The Difrax S-Bottle Warmer; How To Use The Difrax S-Bottle Warmer - Difrax S Handbuch

Assembling the Difrax S-bottle warmer

1) Place the base station
on a stable surface
G
2) Insert the plug into the wall socket
3) Unscrew the bottom with the s-bottle valve from
the S-bottle (VII and VI). These items you don't
need anymore when you directly feed after
warming-up because all the advantages of the
vacuum system in the bottom of the S-bottle
warmer are pr0cessed
4) Press the O-ring valve firmly onto the
B
heating element in the notch with the raised
C
section facing upwards in order to prevent
leakage. Make sure the upstanding part is open
by squeezing it several times
IMPORTANT !
Check the O ring valve before every use. Small tears may
B
cause leaks
5) Place the heating element
C
of the correct size or and make sure the
D E
O-ring valve is still firmly in place
: White bottle base for S-bottle Natural 170 ml
D
and 250 ml
: Black bottle base for S-bottle Wide 200 ml
E
and 310 ml
in the bottle base
6
6) Screw the S-bottle body (V) firmly in place on the
bottle base or
D E
7) Unscrew the bottle ring with the teat and
sealable disk (III, II and IV) from the bottle
body (V)

How to use the Difrax S-bottle warmer

1) Fill the S-bottle via the top with (breast)milk or
water
2) Because the heating element
in the bottle, the S-bottle holds 30 ml less food
than indicated on the volume indicator! Use the
top-up cap to top up the missing 30 ml, fill
A
the cap and add this to the food already in the
A
S-bottle
IMPORTANT !
• Do not heat frozen (breast)milk or frozen water in the S-bottle
warmer. Frozen food must be defrosted thoroughly first before
it can be heated
• Warm up (breast)milk or water first before you add your
(milk or porridge) powders
• The minimum amount of food you can warm up is 90 ml
• Press the operating button
H
S-bottle heater
• Do not fill with liquids > 50˚C
takes up space
C
at least 3 sec. to turn on the
7