SUHNER ABRASIVE LTB 6-500 Betriebsanleitung Seite 24

4.1.1 d /
etAching connecting the suPPly hose
Unscrew the coupling with the exhaust air hose so that it
can be pulled back and off.
Press the hose coupling to disengage it. You can now pull
out the air supply hose.
V
ery shArP BlAde
4.1.2 r
egrinding the BlAde
The blade can be reground with a commercially available
grinding machine. There are special adapter plates avail-
able for SUHNER blades.
V
ery shArP BlAde
4.1.3 h
Ardening the BlAde
Exclusively SUHNER steel must be used. This can be pur-
chased from the area representative or directly from the
manufacturer. Apply the steel under a light pressure. The
last pass should be along the inside of the blade. When
cutting does not improve, the blade must be replaced.
Contact the area representative or the manufacturer for
further information.
24
o
utside edge
When hardening the blade, make sure that you hold the
steel at the correct angle to the blade. When this angle is
too large, the edges of the blade will be rounded off. This
makes regrinding more difficult.
!
4.1.4 g
Use only food grade (FDA approved) lubricants, e.g.
TURBO LUBE GREASE (art. no. 60000078), TURBO
LUBE SPRAY (art. no. 60000077).
!
To fill the grease cup, press in the button. Insert the grease
gun into the nipple on the grease cup, and press strongly
to charge it with grease. Stop when the button has moved
up. Press the grease button at regular intervals and after
cleaning and connecting the nose.
/ i
nside edge
V
ery shArP BlAde
reAsing the BlAde
!