Cleaning, Care And Maintenance; Descaling; Cleaning; What To Do If - STIEBEL ELTRON EBK 5 G automatic Bedienung Und Installation

oPEration

ClEaning, CarE and MaintEnanCE

6. Cleaning, care and maintenance
6.1

Descaling

Almost every type of water deposits limescale at high temperatures.
Therefore, it is necessary to descale the appliance every so often.
Risk of scalding!
Descalers that generate a lot of foam can result in the
appliance overflowing which would put users at risk.
Use environmentally friendly formic acid-based descaling
»
agents.
Do not boil the water while descaling.
»
When the appliance has cooled down, open the lid.
»
Pour in the recommended amount of water and descaler and
»
close the lid again.
Turn the temperature selector to the descale setting (see
»
diagram).
Switch the appliance on by pressing the temperature selector.
»
Leave the descaling agent to take effect and repeat the heating
»
process if necessary.
Draw off all the water and rinse the appliance out several times
»
with cold water.
Boil the maximum possible volume of water and draw this water
»
off once again.
www.stiEBEl-Eltron.CoM
6.2

cleaning

Never use abrasive or corrosive cleaning agents. A damp cloth
»
is sufficient for cleaning the appliance.
The inside of the appliance's glass container can be cleaned if
necessary:
Isolate the appliance from the power supply.
»
When the appliance has cooled down, open the lid.
»
Clean the container and heating element without using any
»
objects with sharp edges.
Close the lid and plug in the mains plug again.
»
If necessary, rinse out the appliance in order to remove any
»
cleaning agent residue.
7.

What to do if ...

7.1

... the appliance develops faults

fault Cause
The appliance does not The appliance is not
heat up. plugged into the mains.
The appliance is not
switched on.
The fuse is faulty.
There is no water in the
appliance.
The appliance switches The appliance is scaled
off before it reaches up.
boiling point.
The hot water flow is The appliance is scaled
significantly reduced or dirty.
despite the draw-off
valve being fully open.
If you cannot remedy the fault, notify your heating contractor. To
facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-000000).
5
4
3
2
1
» remedy
Insert the plug into the
mains supply.
Switch the appliance on.
Check the fuse/MCB
in your fuse box/
distribution panel.
Fill the appliance with
water.
Descale the appliance.
Clean and descale the
appliance.
Nr.:
Typ: EBK 5 G 000000 0000 - - 000000
5l Glas/verre/glass 0 MPa 10l/min
2kW 230V 50Hz 8,7A
Made in Germany
EBK | 19