cecotec ForceTitanium 720 Smart Bedienungsanleitung Seite 16

ENGLISH
Steam ironing
Fill the iron as described in 'How to fill with water'.
1. Plug the appliance into the mains supply.
2. Place the iron vertically and set the temperature with the temperature buttons in one of
the steam-ironing levels. As indicated on the LCD panel, steam-ironing is only possible at high
temperatures (level 6 or over).
3. Preheat the iron until the LCD panel stop flashing.
4. Turn the steam selector to the required setting, according to the different types of fabric.
WARNING: the iron releases steam continuously only if you hold the iron horizontally. You can
stop the continuous steam flow by placing the iron in upright position or by turning the steam
selector off. You can only use steam at the highest temperatures. If the selected temperature
is too low, water may drip from the soleplate.
ECO mode
Press the ECO button for optimal results when steam ironing any type of fabric. This position
guarantees good results saving energy.
Anti-Calc Function
The anti-calc function is a permanent system located inside the water tank to eliminate
impurities from the water and reduce the problems derived from limescale build-up. To prolong
the efficiency of this system, follow these steps regularly:
1. Unplug the iron and allow it to cool down.
2. Fill 3/4 of the measuring cup provided with the iron with water. Add 1 teaspoon of salt and fill
the water tank with this solution.
3. Leave the solution in the water tank for 15 minutes, shaking it occasionally, and empty it.
Repeat this step twice.
4. Fill the tank with fresh water to rinse it and empty it.
Anti-Drip Function
This system controls the water flow to the soleplate at all times. Below a certain temperature, the
antidrip function cuts off the water flow and prevents the iron from dripping water onto the fabric.
Auto-Power Off Function
The iron will automatically turn off if placed in horizontal position for 30 seconds, or in the
vertical position for 8 minutes. To indicate that the iron has been turned off, the unit will beep 6
times and the auto-power off indicator light will blink. The iron can take up to 45-60 minutes to
cool down completely. To heat up the iron again:
1. Pick up the iron or move it slightly.
2. The auto-power off light indicator will stop blinking.
16 FORCETITANIUM 720 SMART
05027_ForceTitanium 720 Smart_Manual_BM.indd 16
MAX OFF
13/11/17 8:57