Operation - Würth EPM 160-E Betriebsanleitung

OBJ_BUCH-0000000218-002.book Page 14 Thursday, August 20, 2015 10:47 AM
Intended Use
This hand-guided orbital polisher is intended for com-
mercial use in industry and trade. It is intended for all
types of polishing work, such as for coated surfaces on
vehicles, for furniture, metal and stone surfaces using
polishing sponges, lambskin and wool pads, for oper-
ation with polishing tools approved for speeds of at
least 500 rpm.
For damage caused by usage other than intended, the
user is responsible.
Product Features
1 Gear housing cover
2 Handle
3 Spindle lock button
4 Gear head
5 Type plate
6 Lock-on button
7 On/Off switch
8 Thumbwheel for speed adjustment
9 Allen key
10 Velcro plate
11 Mains cable
Not all of the accessories illustrated or described
are included as standard delivery.
Tool Specifications
Orbital polisher
Article number
Rated power input
Output
Speed range
Orbital rate
Dia orbit
Tool holder
Application tool diameter
Weight
Class of protection
 Before any work on the machine itself,
pull the mains plug.
Dismounting the Handle
(see figure A)
Loosen the screws with Allen key 9 and remove the
handle 2.
Mounting the Gear Housing Cover
(see figure B)
Loosen the screws with Allen key 9, remove the handle
2 and the gear housing cover 1.
Slide the gear housing cover 1 on again and fasten it
with the screws.
Mounting/Exchanging Polishing
Tools (see figure G)
Place the polishing tool centrally on the Velcro plate
10 and firmly press it on.
Plug the mains plug into the power socket and switch
the power tool on.
Start a test run to check for imbalance and vibrations.
Exchanging the Velcro Plate (see
figure H)
Remove the polishing tool.
Press the spindle lock button 3 and loosen the screw
using Allen key 9. Actuate the spindle lock button 3
only when the power tool is completely stopped.
EPM 160-E
Replace the Velcro plate 10. The groove of the Velcro
plate 10 must engage in the spanner flats of the drive
5707 500 X
shaft; if required, lightly rotate the drive shaft.
1010 W
Press the spindle lock button 3 and tighten the screw
590 W
again using Allen key 9.
160 – 480 rpm
Start a test run to check for imbalance and vibrations.
3200 – 9600 rpm
8 mm
Ø 140 mm
160 mm
 Observe the mains voltage! The voltage of
2.7 kg
the power source must correspond with the data on
II
the type plate of the machine.
Before Starting Operation

Operation

14