monzana 108362 Anleitung Seite 16

16
5. Re-prime the filter tank.
6. Correctly locate the o-ring.
7. Replace the lid (hand tighten) only.
8. Switch on pump. In Climates where the pump may be exposed to frost or freezing,
care must be taken to ensure the pump is protected from damage.
It is recommended that if the pump is not used during winter period it should be drained
completely and store pump in a dry location. Do not replace the drain plug. Store it in
a safe place when not use. An example would be store plug in the filter tank basket.
When you re activate the pump ensure all seals and o-rings are in operational condition,
re-grease if necessary, replace if unsure of condition. Check that the motor shaft moves
freely before re-activation.
WARNING
1.When connecting electric cables to the motor of the pump, be careful to
correctly arrange them inside the connection box, verify that no bits of cable are
left inside the box on closing it. See that the ground wire is correctly connected.
When connecting the motor, follow the wiring diagram supplied with the pump.
2. Be especially careful that no water enters the motor or electrical parts under voltage.
3. In the
adaptations
4. Before
protection devices
electrical and mechanical contacts are correctly positioned and attached.
5. It is advisable to follow the steps listed below before handling the pump in any way.
a) Turn off the voltage to the pump.
b) Lock starting devices.
c) Verify that there is no voltage in the circuits, including ancillary devices and auxiliary
circuits.
d) Wait until motor stops completely. The above list should be considered indicative
and not binding for the purpose of safety;specific safety rules may exist in particular
regulations.
Regularly verify
1. The correct attachments of the mechanical parts and of the support screws of the
pump.
2. The correct position, attachment and condition of the supply cables and of the
insulating parts.
3. The temperature of the motor. In the event of any excessive high, stop immediately
and have it repaired.
4. The vibration of the pump. In the case of any excessive high, stop immediately and
have it repaired..
CAUTION
Owing to the complexity of the cases covered, the instructions for installation,
event that
and supplementary
starting the pump,
of the
www.DeubaXXL.de
the planned use
technical
verify the
motor and that
is not as
rules may be
calibration of the
the protections
specified,
necessary.
electrical
against