Epson TM-U675 Bedienungsanleitung Seite 11

1. Wait until the SLIP light blinks. Then insert the check face up
2. The printer will detect the check and start drawing it in. When
Cleaning the MICR Mechanism
Once a year clean the MICR head with a moistened cleaning sheet.
Use the following or an equivalent commercially available cleaning
sheet:
Note:
Be sure not to use an adhesive cleaning sheet.
Follow the steps below:
1. Load a paper roll in the printer; turn off the power; then open
2. Press the RELEASE button seven times; then close the paper roll
Downloaded from www.Manualslib.com
with the right side of the check against the right side of the
paper inlet as far as it will go. Be sure that the MICR characters
are on the right.
the printer starts drawing it in, let go of the check immediately.
When the printer ejects the check and the SLIP light starts
blinking again; remove the check by pulling it straight up; do
not pull it at an angle.
PRESAT brand (KIC) "CHECK READER CLEANING CARD."
the paper roll cover and turn the power back on while holding
down the RELEASE button.
cover. The printer prints the following message on receipt
paper and the SLIP light flashes.
manuals search engine
English
MICR
characters
on this side
face up
TM-U675 User's Manual 9