Safety Instructions - auna CDC-200 Discman Bedienungsanleitung

SAFETY INSTRUCTIONS

Before you use read the following safety instructions.
• As the laser beam used in this compact disc player is harmful to the
eyes, do not attempt to disassemble the casing.
• Stop operation immediately if any liquid or solid object should fall into
the cabinet.
• Do not touch the lens or poke at it. If you do, you may damage the lens
and the player may not operate properly.
• Do not put anything in the safety slot. If you do, the laser diode will be
ON when the CD door is still open.
• This unit employs a laser. The use of controls or adjustment or
performance of procedures other than those specified here may result
in exposure to hazardous radiation.
• If you do not follow the operating instructions provided, it may
compromise the safety of your product and this may invalidate the
warranty.
• Do not expose the product to dripping or splashing .Do not place
objects filled with liquids,such as vases, on the product.
• If liquid or water spills onto the product, switch it off immediately and
contact your dealer.
• If you are using a mains-powered adapter,do not touch the product with
wet hands.
• The internal battery in this product is not user replaceable .Do not
expose the battery to excessive heat or naked flames. Ensure adequate
ventilation and airflow around the product particularly when charging.
Dispose of the product in accordance with local environmental rules.
• Using the product in rooms or climates with high humidity and
temperatures may cause condensation to form inside the product,
which can damage the product. Use the product in moderate climates
only.
• Do not use your product in extremely hot or cold temperature . Keep
the device away from heat sources, such as radiators or gas/electric
fires. Do not expose your product to naked flames, such as lighted
candles.
• To charge your product,only connect it to a supply source that meets
the safety
• Isolation requirements of EN 60065 or EN 60950-1 for an accessible
safety extra low voltage circuit. For this connection,use either the
supplied microUSB cable or a suitably CE approved power adapter with
the correct USB output rating.
• Power the product using anexternal 5V DC 1A power supply. The
maximum output current is 1A, protected by an internal circuit.
• Before you charge your product,ensure that the available supply voltage
corresponds with the required operation voltage of the product.
• Disconnect your product from the charging power supply if you will not
EN
21