Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
__________________________________________________________________________________
General Product Information
The products are certified heating systems comprising of different components for safe use within
hazardous areas as specified. The products are used primarily to maintain heat and prevent heat loss on
standard drums and gas bottles commercially available. The products are available in standard
configurations and sizes as well as in special customized versions. Each product has a unique part number
and specification which is provided along with this manual.
Note:
For the type specifications please refer to technical specification, the product label or type plate. In the
case of installation difficulties or special requirements it is recommended to discuss and agree suitable
installation procedures. In case of doubt or if necessary please contact us.
(See last page for contact information)
Additional Safety Instruction (product related)
Attention!
It is within the responsibility of the installer and user to check the suitability of the products described
below for implementation inside hazardous areas according to latest EU directives. For proper use and to
prevent electrical shock, injury of persons, animals and fire, international, national and regional
requirements, laws, standards and directives need to be taken into consideration.
The basic requirements during installation and maintenance are to be followed:
- Do not use the equipment for any other purpose than intended!
(See section "General Product Information")
- Check the product specification data prior to installation and operation
(See product type label for designated supply voltage and power ratings)
- Check ingress protection designation for use
(See product type label for IP Rating)
- Check chemical resistance of product in designated are of use
(Do not use product within corrosive atmospheres)
- Check any additional area requirements that may apply
Note:
No installation in hazardous area Zone 0!
- Check ambient temperature range of use
(See values for equipment on type label)
- Allow maintenance and service by authorized and trained staff only
- Ensure that all conductive parts are bonded or connected to earth
- In case of failure or miss-operation disconnect the system immediately from power supply
- The products should never be operated without a residual current circuit breaker device (RCD or ELCB)
1235-OMH FIDR-FIBDR-FIGB-SR R16-0
5 |
P a g e - S e i t e
Werbung
Inhaltsverzeichnis
