Working Advice; Maintenance And Cleaning - stayer BHL112BK Bedienungsanleitung

gb

WORKING ADVICE

Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
Tips
After longer periods of working at low speed, allow the
machine to cool down by running it for approx. 3 mi
nutes at maximum speed with no load.
For drilling in metal, use only perfectly sharpened HSS
drill bits (HSS=high-speed steel). The appropriate
quality is guaranteed by the Stayer accessories
program.
Before screwing larger, longer screws into hard
materials, it is advisable to predrill a pilot hole with the
core diameter of the thread to approx. 2/ 3 of the screw
length.
5_MAINTENANCE AND SERVICE

MAINTENANCE AND CLEANING

Before any
maintenance, tool change, etc.) as well as during
transport and storage, set the rotational direction
switch to the centre position.Unintentional actuation
of the On/Off switch can lead to injuries.
For safe and proper working, always keep the
machine and ventilation slots clean.
When the battery is no longer operative, please refer
to an authorised after-sales service agent for Stayer
power tools.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
Stayer power tools.
TRANSPORT
The battery is tested according to UN document ST/
SG/AC.10/11/Rev.4 Part III, subsection 38.3. It has
effective protection against internal overpressure and
short circuiting as well as devices for the prevention
of violent rupture and dangerous reverse current flow.
The lithium-equivalent content in the battery is below
applicable limit values. Therefore, the battery is
not subject to national or international regulations
pertaining to dangerous mediums, neither as an
individual component nor when inserted into a
machine. However,
dangerous goods may be relevant when transporting
several batteries. In this case, it can be necessary to
comply with special conditions (e.g., concerning the
packaging).
work on the machine
the regulations
DISPOSAL
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into house-
hold waste!
According the European Guideline 2012/19/
EU for Waste Electrical and Electronic
Equipment and its
into national right, power tools that are no longer usa-
ble must be collected separately and disposed of in an
environmentally correct manner.
Battery packs/batteries:
Do not dispose of battery packs/batteries into
household waste, fire or water. Battery packs/batteries
(e. g.,
should be collected, recycled or disposed of in an
environmental-friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be
recycled according the guideline 2013/56/EU.
governing
- 20 -
i m p l e m e n t a t i o n
Li-Ion:
Please observe the instructions in sec-
tion "Transport",