afx light COMBO-LED Bedienungsanleitung Seite 4

other or connect to the connector.
A DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR connector with a
120Ω resistor between the pin 2 and pin 3 of the XLR connector
DMX512 [Address Settings]
This feature allows you to change the device address value.
Press the "MENU" key one or more times until d001 will be display, and then use "UP" or "DOMN" button to choose
the value of "001 ---- 512".
Press ENTER to validate the address.
d001-d512 : 8 channel mode
MASTER SLAVE OPERATING
Set the first COMBO-LED of the link in auto or sound mode. This one is the master device.
Set the others COMBO-LED of the link in DMX mode ( d001 ). These ones are slave devices.
The slave devices will do the same effect as master device.
LASER OPERATING MODE
To switch on the laser light, you must to turn the security key to the On position. If the security key is in off position,
the laser light is disable
MODE setting
DMX : Press the MENU button until d001 will be display then use UP and DOWN buttons to set the DMX
address.
SOUND : Press the MENU button until S1XX to S7XX will be display. COMBO-LED will be operate with sound.
( XX are speed value ( 01 to 09 ))
8 sound modes : S1-- = sound program 1
For each sound mode, you can adjust speed from 1 to 9 ( using Up and Down buttons )
AUTO : Press the MENU button until
( XX are speed value ( 01 to 09 ))
8 auto modes : A1-- = Auto program 1
1. Working channel table
8 DMX channels mode
© Copyright LOTRONIC 2016
S2-- = Sound program 2 ( no flash )
S3-- = Sound program 3 ( flash )
S4-- = Sound program 4 ( effect led )
S5-- = Sound program 5 ( laser )
S6-- = Sound program 6 ( strobe led )
S7-- = Sound program 7 ( Effect led + laser )
A1XX to A8XX
A2-- = Auto program 2 ( no flash )
A3-- = Auto program 3 ( flash )
A4-- = Auto program 4 ( effect led )
A5-- = Auto program 5 ( laser )
A6-- = Auto program 6 ( strobe led )
A7-- = Auto program 7 ( Effect led + laser )
will be display. COMBO-LED will be operate in automatic mode.
COMBO-LED Page 4