Concept KS 3000 Bedienungsanleitung Seite 25

EN
OPERATING INSTRUCTIONS
1. Place the unit on a stable surface or floor to avoid tipping over.
2. Uncoil the supply cable.
3. Connect the plug of the power cord to the wall outlet.
4. Select the required function using the mode selector:
KS 3000
0 = OFF
I = low heating capacity (1,200 W)
II = full heating capacity (approximately 2,000 W)
I + low heating capacity (1,200 W) + fan (turbo)
II + full heating capacity (approx. 2,000 W) + fan (turbo)
KS 3001
0 = OFF
I = low heating capacity (800 W)
II + = middle heating capacity (1200 W) + fan (turbo)
I + II + = full heating capacity (2000 W) + fan (turbo)
KS 3002
0 = OFF
I = low heating capacity (800 W)
II = middle heating capacity (1200 W)
III = full heating capacity (2000 W)
= fan (turbo)
KS 3003
0 = OFF
I = low heating capacity (400 W)
II = middle heating capacity (600 W)
I + II = full heating capacity (1000 W)
= fan (turbo)
5. You may adjust the required room temperature using the thermostat control. In mode I or II the unit will be switched
on and off alternately, thus maintaining the selected temperature.
Note: By following the steps below you may set the temperature more accurately:
Set the thermostat to maximum and switch the unit to heating mode I or II. When the required room temperature is
reached, keep turning the thermostat control slowly down to a lower value, until the unit goes off.
6. After use, move the mode selector to the „ 0" position and unplug the unit from the mains.
KS 3000, KS 3001, KS 3002, KS 3003
23