Philips FC9319 Bedienungsanleitung Seite 13

Replacing the HEPA 13 ilter
Press the ilter cover release button to open the ilter cover.
1
Remove the ilter cover.
2
Take out the ilter and place a new HEPA 13 ilter in the appliance.
3
Fit the two lugs of the ilter cover behind the ridge at the bottom
4
of the vacuum cleaner (1). Then push the ilter cover towards the
appliance (2).
Press home the ilter cover to lock it ('click').
5
Note: Make sure the ilter is properly closed.
Tip: For optimal results, replace the HEPA 13 ilter every 2 years. If you want
to minimise the impact on the environment, you can wash the HEPA 13 ilter.
Washing the HEPA 13 ilter
To wash the HEPA 13 ilter, follow the instructions below.
Rinse the HEPA 13 ilter under a hot slow-running tap.
1
Never clean the ilter with a brush.
Carefully shake the water from the surface of the ilter. Let the ilter
2
dry completely for at least 2 hours before you put it back into the
vacuum cleaner.
Note: Cleaning does not restore the original colour of the ilter, but does restore
its iltration power.
English
13