Protection Circuit - Hifonics Zeus Serie Bedienungsanleitung

INTERCONNECTION

PROTECTION CIRCUIT

If the POWER LED ( 4 ) lits up, the device is in normal operation. If the PROTECT LED ( 3 ) lits up, the device is overheated. If this occurs, the
internal built-in protection circuit shuts down the device automatically. The device should work again properly after cooling down.
AUDIO SIGNAL CABLES
Connect the audio signal cables from the RCA outputs of the head unit to the RCA inputs on the device ( 1 ).
HIGH LEVEL INPUT
The HI LEVEL INPUT ( 2 ) is suitable to connect the device input with speaker wires, if your head unit is not equipped with pre-amplifier RCA
outputs. Extend therefor every regarding speaker cable from your head unit with appropriate speaker cables from your car audio retailer
to the mounting location of the amplifier. Then connect the each matching loudspeaker cable with the cables of the included HIGH LEVEL
input jack.
NOTE: Never use the HI LEVEL INPUT ( 2 ) and the LOW LEVEL INPUT ( 1 ) at the same time. This may damage the device seriously.
4
PHASE
POWER
0°
180°
50Hz 150Hz
PROTECT
ON
OFF
AUTO TURN-ON
3
LPF BOOST LEVEL
0dB +18dB MIN MAX
ZRX200A
ACTIVE SUBWOOFER SYSTEM
2
LINE INPUTS
HI LEVEL INPUT
+L L–
+R R–
BASS LEVEL
CONTROLLER
LOW LEVEL INPUT
1
POWER INPUTS
FUSE
R
L
25A
ENG
GND
REM
+12V
9