Operating Elements - Hifonics Zeus Serie Bedienungsanleitung

OPERATING ELEMENTS

INPUT SENSITIVITY
Turn the volume controller of your head unit to the center medium position and then turn up the INPUT LEVEL controller ( 2 )
until you have an average medium level without distortion. This setting usually provides sufficient power reserves at optimum
weighted signal-to-noise ratio.
LOWPASS FILTER
Set the desired crossover frequency of the low pass filter by using the LPF controller ( 4 ). Hence, only the frequencies below
the chosen crossover frequency will be amplified and the subwoofer plays more precisely and efficient.
BASS BOOST
By using the BOOST controller ( 3 ) you are able to increase the bass boost level from 0 dB to 18 dB.
Caution: Please use the bass boost with care.
BASS LEVEL REMOTE CONTROLLER
Connect the included Bass Level Remote Controller at the BASS LEVEL CONTROLLER input ( 1 ). This allows you to control the
bass level f.e. out of the driver's seat.
PHASE
The PHASE switch ( 5 ) allows you to set the phase between 0° or 180° to match the output signal with the vehicle's interior
acoustic and the loudspeakers of the sound system.
4
PHASE
POWER
0°
180°
50Hz 150Hz
PROTECT
ON
OFF
AUTO TURN-ON
5
10
3 2
LPF BOOST LEVEL
0dB +18dB MIN MAX
ZRX200A
ACTIVE SUBWOOFER SYSTEM
BASS LEVEL
POWER
MIN MAX
LINE INPUTS
HI LEVEL INPUT
+L
+R
BASS LEVEL
CONTROLLER
1
FUSE
R
L–
L
R–
25A
LOW LEVEL INPUT
POWER INPUTS
GND
REM
+12V