Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TECHNICAL DATA
Type KUE12 KUE12.9(E12-designation of
machinery, representative of circular saw)
Voltage
No load speed
Blade size
Arbor size
Cutting Depth
at 90°
Cutting
capacity
Cutting Depth
at 45°
Bevel capacity
Machine weight
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts
NOISE INFORMATION
A weighted sound pressure
A weighted sound power
K
&K
pA
wA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission
value:
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ from
the declared value depending on the ways in which
the tool is used especially what kind of workpiece is
processed dependant on the following examples and
other variations on how the tool is used.
How the tool is used and the materials being cut or
KUE12
KUE12.9
20V
Max**
5200/min
165mm
20mm
54mm
42mm
0-50°
3.5kg
2.8kg
L
=80 dB(A)
pA
L
= 91 dB(A)
wA
3dB(A)
Cutting wood:
a
= 1.97m/s²
h,w
Uncertainty K = 1.5 m/s²
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
Hex key
Parallel guide
Vacuum adaptor
165mm saw blade
Battery pack
Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece. This machine
cannot be used to work on iron metal.
KUE12
KUE12.9
1
1
1
1
1
1
1
1
2(KAB21)
/
1(KAC21)
/
9
EN
Werbung
Inhaltsverzeichnis
