Proper Use; General Information; General Safety Instructions - Rev Ritter Flux 48 Montage- Und Bedienungsanleitung

GB
Flux 48W
Assembly and operating instructions
INTRODUCTION
Dear Customer,
We'd like to thank you for purchasing our product. Please read the following operating instructions thoroughly
before using this product for the first time and keep it handy for future reference (S1).
Please check the product before use for any damage.

PROPER USE

• Luminaire for ceiling mounting on normally flammable surfaces in dry spaces.
• Not suitable for through-wiring.
• The product conforms to the appropriate European CE directives (S2).
• This product conforms to the appropriate European safety standards.
• The product is IP20 rated and suitable for use in dry interior spaces (S3).
• The product is intended exclusively for household use or similar purposes. It must not be used for commercial
purposes!
• The product may only be used only for the purpose for which it is intended, in accordance with this user manual!
• The product is not suitable for rough use (e.g. construction sites)!
• The product is not intended for use by persons (including children) whose physical, sensory or mental abilities
are limited or who lack experience and knowledge! These persons may only use the product if they are
supervised by a person responsible for their safety, or if they have been inducted into how to use the product!
The supervision and use of this product must be carried out by a responsible person!

GENERAL INFORMATION

• Handle this product carefully. It can be damaged by shocks, blows or by being dropped, even from a low height!
• Only use the supplied original parts!
• Do not use additional components!
• This product has no replaceable parts. Do not attempt to open or repair this product!

GENERAL SAFETY INSTRUCTIONS

• Please observe the technical specifications!
• Please follow this instruction manual and keep it in a safe place!
• Please pass on this instruction manual to a subsequent owner!
• Not to be used by children!
• Do not operate a defective product!
• Connection and installation must be carried out only by a trained electrician (S4)!
• Always disconnect from the mains before starting work (S5)!
• Switch off the house fuse!
• Never look directly into the LED light source! The light spectrum transmitted may contain blue components (S6).
• Always allow to cool down sufficiently and for cleaning purposes disconnect the luminaire from the power supply
and secure the electric circuit against being switched on again.
• Use only in connection with a sufficiently fused 230V~ installation!
• Must not be used in areas that represent an explosion hazard (e.g. carpentry workshop, paintshop, or similar)!
• Do not use in the immediate vicinity of flammable materials!
• Do not immerse in water or other liquids!
• Do not operate with wet hands!
• Never undertake repairs yourself. Repairs may only be carried out by the manufacturer or an authorised service
representative.
• The light source of this luminaire may only replaced by the manufacturer, an authorised service technician or a
similarly qualified person!
• Always install at least 1m away from illuminated surfaces — the connection cable in particular must not be
illuminated or come into contact with the metal housing — and observe the required minimum distances (S7)!
• The product must remain freely accessible (also when in use)!
• Do not open the housing! (S5)
• Never operate with an open housing, or missing or damaged terminal compartment cover.
• A conversion or modification of the product affects product safety. Caution: risk of injury! A conversion or
modification of the product must not be carried out!
9