Inhaltsverzeichnis
Werbung
Spannschulter-Messgerät /
Cam Angle Gauge
HSK 25 - HSK 100
7.
Indicator
7.1.
Disassembling
When the indicator needs to be replaced, remove the adjustment stop screw (sealed
when new) and remove the indicator. Remove the probe and bolt it into the new
indicator.
7.2.
Installation
Install the indicator with the probe installed into the bore and give the indicator a
preload of 2,5 mm. Clamp indicator in this position. Check the function and repeatability
of the indicator.
Attention!
Do not block the indicator by over-tightening.
After replacement, the adjustment of the indicator must be checked with the master
taper (see section Gauge setting)
Spannschulter-Messgerät_D+E
Copyright © Diebold 2012-12 Ersteller: kh
Seite 13 von 14
Werbung
Inhaltsverzeichnis
