rodac RC118N Benutzerhandbuch Seite 7

USER'S INSTRUCTIONS FOR RC118N / RC119N / RC120N
2
12
3
5
2
* The various products are differentiated by the tube length and the extruded product type.
1.1. Technical details
Model Basic Cartridge Soft-pack
setup
*
RC118N For
soft-pack
- -
RC120N
**
RC119N
For
cartridge
# Basic setup: It is the mode with which the gun is assembled at the factory and provided to the client.
* Cartridge based conversion kit: plastic spacer with gasket (included in the supply).
** Bag based conversion kit: bag holder, tube scraper, piston collecting soft-pack, soft-pack awards cone (included in the supply).
1.2. Noise emissions and vibrations
When releasing the lever, the level of equivalent A-weighted sound pressure, measured at a 50 cm. horizontal distance during the
application of a sealant and with a gun feeding pressure of 6 Bar, is > 80 dBA. Therefore the use of ear defenders is recommended.
The hand/arm system vibration level was detected on an equivalent model and it is less than 2,5 m/g2.
1.3. Storage
The gun is supplied in a single KEB WHITE ST/B343 cardboard box, with a 2.8-3 mm. thickness low flute; the gun is held in a
polyethylene bag. Keep at a temperature between -5°C and 45°C, with ambient humidity not exceeding 70%.
2. CAUTION
This symbol draws your attention to safety related issues. Read carefully the recommendations included and strictly comply with them.
Before using the gun read the instructions and strictly comply to them.
Before any repair, maintenance and refill operations, disconnect the air feed.
Before any repair and extraordinary maintenance operations, contact the gun dealer or trained staff. Improper interventions will render
the warranty null and void.
When choosing the product to extrude and before using the gun, check the product compatibility with the work environment and the
adopted individual protection devices, according to its safety data sheet.
During usage, safety devices (individual protections) are to be worn on top of one's clothes, in compliance with the product safety data
sheet. Using safety glasses and ear defenders is recommended in any case.
During tooling operations hand abrasions may be possible, therefore wearing gloves is recommended.
7 9
11
1
4
6
10
1
7 9
L
Cartridge
(ml)
≤ 310 ml
-
≤ 310 ml
1. PRODUCT DESCRIPTION
D
8
1)
2)
3)
2
4)
5)
3
6)
7)
8)
9)
4
10) CE mark
11) Exhaust air outlets
5
6
12) Safety hole
8
PNEUMATIC APPLICATOR GUN
Rodac international B.V.
Njverheidsstraat 1 6130 AJ Sittard
MAX PRESSURE 10 bar (145 psi)
Soft-pack L H
(ml) (mm) (mm)
≤ 400 ml 307 263
≤ 600 ml 440 263
≤ 400 ml 556 263
7
Body of the gun
Front ring nut
Control lever
Handle
Pressure regulator
Feeding: ¼ gas male threaded connector
Material holder tube
Dump valve
Rear ring nut
mese - anno
D Net Total
weight mass
78 1125 g 1420 g
78 1100 g 1365 g
78 1300 g 1660 g
Connec- Pressure
tion maxim
1/4"GAS 10 Bar
maschio 145 psi
1/4"GAS 10 Bar
maschio 145 psi
1/4"GAS 10 Bar
maschio 145 psi
Manual - English