Periods Of Non-Operation; Troubleshooting - Electrolux RNN2800AOR Benutzerinformation

10 www.electrolux.com
About 12 hours prior to
defrosting, set a lower
temperature, in order to build
up sufficient chill reserve for
the interruption in operation.
A certain amount of frost will always form
on the freezer shelves and around the
top compartment.
Defrost the freezer when the frost layer
reaches a thickness of about 3-5 mm.
1. Switch off the appliance, or pull out
electrical plug from the wall socket.
2. Remove any stored food, wrap it in
several layers of newspaper and put
it in a cool place.
WARNING!
Do not touch frozen
goods with wet hands.
Hands can freeze to the
goods.
3. Leave the door open.
In order to speed up the defrosting
process, place a pot of warm water in
the freezer compartment. In addition,

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
The appliance does not
operate.
The appliance is noisy.
The compressor operates
continually.
4. When defrosting is completed, dry
5. Switch on the appliance.
After three hours reload the previously
removed food into the freezer
compartment.

6.5 Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:
1. Disconnect the appliance from
2. Remove all food.
3. Clean the appliance and all
4. Leave the door/doors open to
Possible cause
The appliance is switch‐
ed off.
The mains plug is not
connected to the mains
socket correctly.
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
Temperature is set incor‐
rectly.
remove pieces of ice that break away
before defrosting is complete.
the interior thoroughly.
electricity supply.
accessories.
prevent unpleasant smells.
WARNING!
If the cabinet will be kept on,
ask somebody to check it
once in a while to prevent
the food inside from spoiling
in case of a power failure.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock‐
et. Contact a qualified elec‐
trician.
Check if the appliance
stands stable.
Refer to "Operation" chapter.