Becton Dickinson 5513E Bedienungsanleitung Seite 11

REF 5513E/5514 series is intended for use in the electromagnetic environment specified below�
The customer or the user of REF 5513E/5514 series should insure that it is used in such an environment�
Immunity test
Electrostatic discharge (ESD)
IEC 61000-4-2
Electrical fast transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power supply
input lines
IEC 61000-4-11
Power frequency (50/60 Hz)
magnetic field
IEC 61000-4-8
Note: U is the a�c� mains voltage prior to application of the test level
Τ
Guidance and manufacturer's declaration — electromagnetic immunity
IEC 60601 test level
±8 kV contact
±2/4/8/15 kV air
±2 kV for power supply lines
100kHz repetition frequency
±0�5/1kV line to line
0% U ; 0�5 cycle at 0°, 45°, 90°,
Τ
135°, 180°, 225°, 270°and 315°
0% U ; 1 cycle and
Τ
70% U ; 25/30 cycles
Τ
Single phase: at 0°
0% U : 250/300 cycle
Τ
30 A/m
50 Hz/60Hz
Compliance level
±8 kV contact
±2/4/8/15 kV air
±2 kV for power supply lines
100kHz repetition frequency
±0�5/1kV line to line
0% U ; 0�5 cycle at 0°, 45°, 90°,
Τ
135°, 180°, 225°, 270°and 315°
0% U ; 1 cycle and
Τ
70% U ; 25 cycles
Τ
Single phase: at 0°
0% U : 250 cycle
Τ
30 A/m
50 Hz/60Hz
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic
tile� If floors are covered with synthetic
material, the relative humidity should be at
least 30%�
Mains power quality should be that of a
typical commercial or hospital environment�
Mains power quality should be that of a
typical commercial or hospital environment�
Mains power quality should be that of a
typical commercial or hospital environment�
Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment�
11